X-Git-Url: http://git.sameswireless.fr/l2tpns.git/blobdiff_plain/4d7677820087558df4836c006509903fa0f6d83b..7cf822a64f5e28285b961bd75693ad9a7f63e47e:/Docs/manual.html?ds=inline diff --git a/Docs/manual.html b/Docs/manual.html index 8dd2532..3d1adf9 100644 --- a/Docs/manual.html +++ b/Docs/manual.html @@ -191,14 +191,6 @@ user, both a primary and a secondary. If either is set to 0.0.0.0, then that one will not be sent. </LI> -<LI><B>save_state</B> (boolean)<BR> -When l2tpns receives a STGTERM it will write out its current -ip_address_pool, session and tunnel tables to disk prior to exiting to -be re-loaded at startup. The validity of this data is obviously quite -short and the intent is to allow an sessions to be retained over a -software upgrade. -</LI> - <LI><B>primary_radius</B> (ip address) <LI><B>secondary_radius</B> (ip address)<BR> Sets the RADIUS servers used for both authentication and accounting. @@ -692,14 +684,10 @@ killall -HUP l2tpns The signals understood are: <UL> -<LI>SIGHUP - Reload the config from disk and re-open log file<P></LI> -<LI>SIGTERM / SIGINT - Shut down for a restart. This will dump the current -state to disk (if <EM>save_state</EM> is set to true). Upon restart, the -process will read this saved state to resume active sessions.<P> +<LI>SIGHUP - Reload the config from disk and re-open log file</LI> +<LI>SIGTERM / SIGINT - Shut down.</LI> <LI>SIGQUIT - Shut down cleanly. This will send a disconnect message for -every active session and tunnel before shutting down. This is a good idea -when upgrading the code, as no sessions will be left with the remote end -thinking they are open.</LI> +every active session and tunnel before shutting down.</LI> </UL> <H2 ID="Throttling">Throttling</H2>